Konica MYIRO scan measurement

Important to know is that the orientation of the ruler decides the patch sequence, you cannot change the patch sequence by starting scanning from the other end of a color bar.

Keep the metal bar below the printed Color bar and the spot measuring hole to the right

Press the scan button, wait for the signal (the LED on top will change color), push or pull the MYIRO over the bar and release the button after that.

If you receive measurements with the patches in reverse order you should change the orientation of the ruler versus the printed Color bar 180 degrees.

More information on setting up the MYIRO for MeasureColor van be found here: myiro_setup_and_troubleshooting